ROSEBROOK 360°-3D TRACING VALVES

The Rosebrook 360° 3D series offers the most advanced tracer technology available. These units offer mobility on up to three axis and operate at higher flow and pressure than other tracers systems. There is no chatter, binding or sticking at any feed rate from ¼ to 100 IPM and accuracy is maintained at any pressure from 150 to 1,500 PSI through the use of our exclusive Crescent Ground spools. An upper micrometer dial is provided to control all feeds for 360° tracing and a lower dial controls 3D plunge rate and retract. In addition a stylus counter balance adjustment screw permits external adjustment to lighten template pressure when using a heavy styli.
 
 
 

MODEL 2000

The Model 2000 traces all angles on the x and y axis and is designed for use on flatwork where the application does not require up and down motion. The Model 2000 utilizes a universal stylus which reacts to side deflection only. Manual or semi-automatic operation is controlled by means of a simple one hand lever with fingertip "on-off" trigger.
 
 
 
 

MODEL 3000

The Model 3000 is a semi-automatic model which features full mobility on the x, y and z axis. The Model 3000 is designed for full 3D motion and cutting. The operator-controlled model utilizes a simple one hand lever with fingertip "on-off" trigger to switch from manual to semi-automatic operation. Universal stylus reacts to both side and end deflection.
 
 
 
 
 
 
 

MODEL 6000

The Model 6000 is a fully automatic tracer which offers full mobility on the x, y and z axis and be used in the semi-automatic or manual mode as well. The model 6000 requires no operator to complete a predetermined cycle. The universal stylus reacts to both side and end deflection and can set for full 3D motion cutting.
 
 
 
 
 
 
 
 
 
 

MODEL 7000

The fully automatic Model 7000 is designed to trace all angles on the x and y axis and is designed for use on flat work where the application does not require up and down motion. The Model 7000 reacts to side deflection only. Like the Model 6000 this, unit does require an operator to complete a predetermined cycle and may also be used in the semi-automatic or manual mode.
 
 
 
 
 
 
 
 

180° VALVESxxxPARTS/REPAIR xxxCONTACT USxxxHOME xxxFAQ'S